Switch protocol KOYO PLC from K- Sequence to DirectNet.
Someone has found problem in the CPU 250-1 of KOYO PLC on K- Sequence communication mode which can not run on DirectNet mode Sure! as We need to change protocol from old to new protocol which is K- Sequence,How to if you need to change the protocol to DirectNET. Could you follow thus as step and picture below.
Step 1.Click open program file.
Go to Setup Sec. Comm Port to Change the protocol.
Click menu bar : PLC–>Setup–>Setup Sec. Comm Port….
The protocol now is K-Sequence. Switch to DirectNET, then write to the PLC.
Step2. Click icon write config
Follow the step as below.
Step3. Click to close Setup windows.
After that we don’t save,So
Step 5. Click No
Go to Link Setup… dialog box .
Clcik menu bar : PLC–>Link Setup. . .
Step 6. Edit Link information.
Change protocol to DirectNET, and should be change the name and description.
Step 7. After changes finished click “Auto” and “Accept”.
Close dialog box
The CPU 250-1 protocol now is DirectNET.
Confirm again in Setup Sec. Comm Port. Go to Menu : Setup Sec. Comm Port .
The CPU 250-1 protocol already changed to DirectNET.
