DIY:Low Cost Dim Light in the light LED

This is car after installed.

Equipment needed.
1. Tube LED. A Super brite. Color tube needs 2 or more (my select blue).
2. R. (the resistance) value 470 ohm - 1.2 K Size 1 / 4 W. 2 a.
3. light cable, shrink tubing for the strap line.
4. stem the fire line for the cable car. (Dispensable).

new vios dim light with LED

equipment for DIY

Begin operation by the LED., R and splice the cable. When looking into the tube LED. Bucktoothed to see whether the size is not equal. Of the stem is larger than -, part of the stem is smaller than + the + through to fire into the legs R. ครับ that this form.

If using a single tube and then I have found that trial will not reflect light How. Add to my tube for another 1 to re-emit a effects of light. To make it more reflective .

LED

Then make a strap with shrink tubing to be sure I just pose a LED. 2 tube with the apologize. take a single tube to see instead.

Try to take the battery or power approximately 12-15 V. not see the error that will not alert.

LED testing

The call to bring the female to wait on the form you not skip this step to Convenient because the reason I put the time and the tube will change color change , You must not enter the cut line and then take it

Then to see the lamp store car.

Top of the globe to stem the cable is wired to the 3 line is white, green, red. Calls for a red light is a dim light is white light + and -

If you are not using it to cut the stem - to fire the second line this ครับ. Will simply have a single red light นะครับ part - is to the body instead.

I remove the stem and then soldering the cable inside the cut line will not need to see it successfully is another good ครับ has the form.

To be a tube of LED. To put it in the light . The original light of vios-2006 will be known ventilation of vios-2007 but is not direct but clasper of spring and the lamp is known that is quite large. Is not known whether ventilation . But I do not care ครับ box to release the rest.

Then the cable to the LED. Then came over a hundred are known out. With a simple cable to a hundred. I bring a cable and then intertwine it before curling like hook and then hook line and then pull out tube LED. Go into the light easily.

Tube made of LED. Then put to the back page of the original lamp.

When look in to

Then make a hundred cable through knowledge of the drainage of the rubber waterproof light. To be able to have a close confidant. (Sorry, not the photograph and then again) to penetrate new ones.